80cm Tecatel Satellite Dish Kit with LNB and Support
Tecatel 80cm Satellite Dish Kit with LNB and Support
This kit of satellite dish, LNB and wall bracket has everything you need to receive the Astra 19.2ºE and Hispasat 30ºW satellites, and in general, any satellite with EIRP above 46dBW.
This inexpensive kit allows the installation of an 80 cm diameter dish antenna on a wall thanks to the support it incorporates, in addition to allowing the reception of the aforementioned satellites thanks to the LNB. It also includes the hardware and the fastening for the installation of the antenna to the bracket.
This kit does not include hardware or plugs for mounting the support on the wall. The connectors and the coaxial cable to carry out the connection to the decoder are not included either.
With the Tecatel 80cm satellite dish kit, LNB and stand you can enjoy the free channels received by the Astra 19.2ºE and Hispasat 30ºW satellites.
What does this kit include?
- Ø 80 cm satellite dish of Tecatel:
- Diameter of 740 x 800 mm
- Focal length 350 mm
- Efficiency greater than 80%
- Electro-galvanized sheet steel reflector
- Thickness of the reflector 0.65 / 1.2 mm
- Offset angle of 26º
- Gain of 38.6 dB at 12.5 Ghz
- Economic LNB, which may vary according to availability, has the following specifications:
- 1 Output
- Type F connector
- Impedance 75Ω
- Support for 80 cm antenna, Televes 7393
How to install a satellite dish?
To install a parabolic antenna you need mainly a hammer, drill, drill bit, wrench, handle for the placement of the dowels, compass and marker, in addition to all the components of the satellite dish.
You have to choose the ideal point to install the satellite dish, which must be free of obstacles to pick up the best signal. Once this has been done, the support must be placed on the wall (check that the plate is horizontal with a level).
Then the antenna must be placed, better with the plate facing down following the instructions given by the manufacturer to attach the antenna arm and place the support. The antenna is hung in the holder leaving the screws somewhat loose for lifting and turning.
|Size||80 cm to 95 cm|
|Mast max. diameter||60 mm|
We found other products you might like!
Kit 80 cm dish Daxis, LNB and Support€43.77 Tax included
Dowel, Lag Screw and Washer Kit (4 units)€2.06 Tax included
Steel 80cm Offset Satellite Dish Antenna Tecatel€52.44 Tax included
Satellite IPTV Receiver OTT Qviart OG S 4K Linux CA€89.00 Tax included
60cm satellite dish with LNB and Tecatel support€26.12 Tax included
Roll of 25 meters of Tecatel PC100 black coax cable€4.14 Tax included
Conversor LNB Monoblock de 4.3º€16.30 Tax included
4K Android Satellite Receiver ARIVA ATV Twin Tuner€183.16 Tax included
80cm Dish Kit + LNB + Cable (20m) + Support + Connectors€64.90 Tax included
Kit Satellite Dish 80cm + LNB + Support + APEBOX S2€106.47 Tax included
Box x8 Offset Satellite Dish 80cm Steel Engel€194.05 Tax included